QymCAD: starší verze ke stažení

What changed
Added
- One way every tool works. Sketch, Part and Assembly tools share one bar and one box at the geometry: what was
selected before the tool is taken, values are fields with formulas and drivers, Enter applies, Esc cancels.
- Sketch: splines, ellipses and arcs of an ellipse as real curves - trim, extend, offset, constraints and
dimensions over any curve; fillets and chamfers at any corner, also where two lines cross, by radius, chord, arc
length, two legs or a leg and an angle; a rectangle as one shape with its turn and centre.
- Sweep along edges of a body, followed through rebuilds; a sweep starts where its profile is drawn.
- Profiles taken by a box for an extrusion and a revolution; the line of an inner contour is taken by a click
next to it, on the sheet and in 3D.
- Undo inside a sketch walks the sketch's own steps; a finished sketch is one step.
- The status line counts the faults of the document and leads to each one; every warning and error is said in
words, in its colour.
- Kazakh and Ukrainian - the whole interface.
- Two icon sets, Default and Flat, switched in Settings -> Icon Themes; a set of one's own is added there too.
- The panels are laid out by hand: dragged to any edge or onto another panel, hidden and shown, in Settings ->
Layout.
- Graphics: the program picks a card that draws, starts in a safe mode after a failed start and says so.
- Help -> Support the author.
Fixed
- Fillets and chamfers on heavy parts: the check of a value answers in about a second, edits rebuild several times
faster.
- "Finish" goes up the tree one level after jumps by links.
- A loft takes its sections clicked in 3D; a hole keeps its recess and its shifts when edited.
- Every body of a part goes into STEP, glTF and 3MF.
- The Windows build; the macOS disk image carries a note in every language.
- About 280 more faults found by working through the program by hand.
Changed
- The document format changed again, with no backward compatibility: a project saved by an earlier build opens, but
a rebuild may lay some fillets, chamfers and planes differently.

New Contributors
- @basson made their first contribution in #26
- @styx made their first contribution in #20
- @vitassuper made their first contribution in #24
- @Ravva made their first contribution in #49
- @pavver made their first contribution in #75
- @n0tfr3shm1lk made their first contribution in #59
- @qmlxml made their first contribution in #117