Aquesta és una versió anterior. La versió actual és la 7.6.7. LycheeSlicer 7.6.7 · Data de publicació:
Fitxers d’instal·lació 7.5.5
| Arquitectura | Tipus | Àmbit | Mida del fitxer | Baixa | SHA256 |
|---|---|---|---|---|---|
| 64 bits | EXE (NSIS) | Tots els usuaris | 203,7 MB | mango-lychee.nyc3.digitaloceanspaces.com | VirusTotal |
L’enllaç i l’SHA256 provenen del manifest comunitari del Gestor de paquets del Windows. Convé comparar el hash del fitxer baixat abans d’executar-lo.
Notes de la versió
Auto Support Improvements & New Printer Support. This stable release focuses on refining the new Auto Support system introduced in 7.5, making it more precise, smarter and more reliable, while also adding support for a highly requested printer. [HOTFIX 7.5.5] We fixed an issue where overhang supports were no longer working.
New 🎉
New Resin Printers Compatibility
- Piocreate Halot X1
Auto Support Improvements ⚙️
Improved Overhang Support System
- Added dynamic spacing based on angle
- Users can define spacing at 0° and at a maximum angle
- Added 3 new overhang support presets, automatically calculated based on supported volume
Smarter Support Placement Between Close Islands
- When two islands are closer than the support tip size, only one support is now placed
- This single support efficiently supports both islands
- Result: fewer supports, cleaner prints
Maximum Angle for Reinforcement & Stabilization
- Added a maximum angle parameter for reinforcement and stabilization supports
- Works similarly to overhang angle settings
- Gives better control over where supports are generated
Improved Reinforcement Point Placement
- Reinforcement points are now prioritized on overhang surfaces
- Leads to stronger structural support where it matters most
Mini Support Filtering
- Added a filtering system to prevent extremely small mini supports
- Reduces unnecessary supports and improves print cleanliness
