Aquesta és una versió anterior. La versió actual és la 3.2.209. EasyEDA Pro 3.2.209 · Data de publicació:
Fitxers d’instal·lació 2.2.39.2
| Arquitectura | Tipus | Àmbit | Mida del fitxer | Baixa | SHA256 |
|---|---|---|---|---|---|
| 64 bits | EXE (Inno Setup) | Usuari actual | — | image.easyeda.com | VirusTotal |
| 64 bits | EXE (Inno Setup) | Tots els usuaris | — | image.easyeda.com | VirusTotal |
L’enllaç i l’SHA256 provenen del manifest comunitari del Gestor de paquets del Windows. Convé comparar el hash del fitxer baixat abans d’executar-lo.
Notes de la versió
- Fix the problem that multi-way wiring can automatically go out without clicking the left button
- Export the flying needle file to a zip archive
- Fixed the problem that the attribute value of the 3D shell side grooved baseline could not be saved
- Fixed the issue of exporting Gerber with duplicate aperture
- Fixed the issue that restoring after removing unused pads only restored part of the pads
- Fixed the problem of abnormal differential pair routing in some cases within the constrained area
- Fixed the problem that the device settings were added to the BOM or went to the PCB as no, and the exported PDF styles were inconsistent.
- Fixed the problem that the export BOM was ticked with JLCPCB price and inventory not successfully exported.
- Fix schematic theme set to Altium style, bottom reuse module diagram page preview mask gray range is wrong
- Fixed the problem that after the last digit of the placement component is modified by TAB to 0, the consecutive placement of the digits will not increase the order
- Fixed the problem of exporting PADS Chinese garbled characters
- Fixed the problem of client side block selection device replacement error
- Fixed an issue where reuse module names within the team were not case sensitive
- Adjusted export Gerber precision copy to mil units
- Fixed the problem that the TAB may be blank for device standardization under the PCB
- Fix the problem of fully offline client side binding system library encapsulation error
- Fixed the issue that combining subgraphs would encapsulate missing in some cases
- Fix the problem that closing the client side did not successfully close the project
- Fixed the problem that the exported BOM did not respond in some cases
- Adjust the adhesive expansion of the panel manufacturing file to 0mm
- The client side adds 3D library folder duplicate name detection to solve the problem that the 3D model cannot be loaded due to the same folder name on different paths
- Support windows arm64 installer
- Preliminary support for importing PADS Pro schematics and symbol libraries
- Fixed bugs in multiple APIs
